What am I doing wrong here?Īfter install everything and start the service, try close your terminal and open it again, then try pull your image Edit I tried sudo'ing the command, but to no avail. I then tried running the image again, but with the same result: $ docker run -name mynginx1 -P -d nginx INFO Docker daemon commit=76d6bc9 execdriver=native-0.2 graphdriver=aufs version=1.9.0 WARN Your kernel does not support swap memory limit. Daemon option -bip can be used to set a preferred IP address INFO Default bridge (docker0) is assigned with an IP address XXX.XX.X.X/XX. This suggests that the Docker daemon is actually already running, but to be sure I just started the Docker daemon manually: $ sudo docker daemon
Hint: Some lines were ellipsized, use -l to show in full. Nov 06 08:41:48 kramer65-VirtualBox systemd: Started Docker Application Container Engine. Nov 06 08:41:47 kramer65-VirtualBox systemd: Starting Docker Application Container Engine. Loaded: loaded (/lib/systemd/system/rvice enabled vendor preset: enabled)Īctive: active (running) since vr 08:41:48 CET 15min ago rvice - Docker Application Container Engine.So I checked out whether Docker was running: $ sudo service docker status
Is the docker daemon running on this host? I've installed Docker on a VirtualBox Ubuntu 15.10 (Wily Werewolf) installation and as suggested here I then tried running a basic nginx Docker image: $ docker run -name mynginx1 -P -d nginxĬannot connect to the Docker daemon.
I want to make a move to Docker, so I've just started to mess around with it.
0 kommentar(er)
